Interior decoration of a frame house

Materials

Publication date: 02/06/2020

7

15450

  • Little secrets to get started
  • Variety of materials
  • New materials worth paying attention to
  • Initial stages of work
  • Best video on the topic

So, when the frame house is almost completed, the most interesting part begins - the interior decoration of the frame house. It gives the building a complete look, makes the house suitable for habitation and is the final stage in the construction of a frame house.


Interior decoration of a frame house using wood

Several rules for successfully finishing a frame house

Before you start finishing, be sure to follow some important rules on which the final result will depend. The main recommendations include the following points:

  • You shouldn’t start decorating every room at the same time. It is better to start by making renovations in one room, for example, in the bedroom, and then gradually decorate other rooms;
  • It is better to start repairs in a room that is located as far as possible from the entrance. In this case, this room can be closed with a door to prevent dirt and debris from getting into it when finishing work is carried out in other rooms;
  • You should start finishing only after all the wires, pipes and other communication elements have been hidden. All these components can be covered with plasterboard, wood panels, plastic and other finishing materials;
  • It’s better to start by finishing the ceiling, and then gradually working your way down to the floor;
  • It is advisable to cover the already finished surfaces with film so that dust and dirt do not fall on them, and it is better to seal the joining elements with tape.

Little secrets to get started

Before you begin finishing, please read the following points. Compliance with the stages and rules of work allows you to finish the premises faster, spending less resources, including time and material.

  1. Do not start decorating each room at the same time. It is much easier to finish one room first, in which you can relax or even spend the night, and then gradually move on.
  2. Start the renovation in the room that is farthest from the entrance. And then you can close it after finishing so that dirt does not get in from other rooms. Passage rooms are finished at the very end.
  3. Finishing should begin only after all wires, pipes, and other communications have been connected. Today they are hidden with drywall, tiles and other materials.
  4. In the room, first of all we finish the ceiling, gradually lowering down.
  5. If you don't want to constantly clean the house, cover the space free from decoration with film. Seal the joints with construction tape.


Rough finishing of walls prepares walls for painting or gluing

No matter how much you would like to move into a house as quickly as possible, it is better not to rush into this matter. What affects the speed of repair?

  1. The complexity of the chosen finishing methods.
  2. Possibility to quickly buy material and order delivery.
  3. Your financial capabilities.
  4. Unexpected circumstances - illness, crisis, etc.

If you are interested in the average time spent on interior decoration, then pay attention to the following figures: in a month you can complete the complete decoration of a small house of 35-40 m2. The figure also depends on the composition of the team, if you plan to hire workers, on your own experience, on design decisions, etc. In addition, the finishing can hide the electrical wiring, so it must be done carefully.


Natural style

If you want to do the interior decoration of a frame house yourself, having free time is extremely important. If you have a six-hour work week, and you plan to do repairs only in the evenings, it can drag on not only for months, but also for years. Especially if your home is 100-250 km away. m.

Finishing of premises consists of two main stages:

  • rough
  • finishing

Rough finishing includes all the preparatory work - preparing walls for painting, preparing the floor for laying tiles, etc. Finishing includes the actual finishing itself - laying tiles, laminate flooring, painting walls, gluing wallpaper, etc.


Beautiful bathroom decoration

Parquet and cork flooring

Parquet boards and cork are perfect for finishing the floor. These products allow you to create a smooth and durable floor covering that will look perfect in the design of a frame house.

Parquet boards are often used for decorative flooring; the main thing is to choose the right material in terms of color and composition. It can be laid in different ways - deck laying, herringbone, diamond or square laying. After installation, the parquet should be additionally sanded with a special apparatus, tinted and coated with a special varnish (at least three times).

Cork is not considered as popular a flooring material as parquet boards. But recently it has become in increased demand. However, it is not recommended for use in rooms with high loads, because the base can be easily damaged by sharp edges of furniture.

Finishing

After the surface of the walls and ceiling is leveled with materials such as:

  • drywall;
  • plywood;
  • OSB.

Work will definitely be required to improve the appearance of the surface decoratively. Inside the house, finishing can be done using.

Wallpaper

Simple and popular material. Inexpensive are paper wallpapers that are easily glued to a previously prepared surface.

In addition to paper, the following can be used for interior decoration of a frame house:

  • vinyl;
  • textile;
  • non-woven;
  • foam film.

Coloring

The surface inside the house can be painted with various dyes. Depending on the type of product used for cladding, the most suitable type of paint is selected.

To ensure reliable attachment of the paint and varnish substance to the surface, the base must be primed with a properly selected primer.

Decorative plaster

This type of finishing work can be done on drywall and after covering the walls with OSB boards.

To obtain a high-quality coating, you need to follow the technology of applying plaster. Plastering plasterboard is done with extreme care. When applying the plaster layer, its thickness should not exceed 10 mm.

Alternative materials

In addition to wood, other types of materials can be used to decorate walls from the inside, namely:

  • glass wallpaper . This is a decorative wall covering that has a lot of positive qualities. They have high moisture resistance and fireproof properties, for this reason this material will be an ideal coating for the walls of a frame house. In addition, there is a wide variety of colors and patterns that can diversify the style and interior design;
  • decorative plaster . This material will be an excellent base for walls. A variety of colors will allow you to diversify the overall atmosphere. Due to the fact that the mixtures are highly resistant to moisture, they can be used to decorate the walls of bathrooms, toilets, and kitchens;
  • drywall _ This universal material is perfect for covering walls and ceilings. The flexibility and softness of the base allows you to give it different shapes. It is often used to make multi-level ceilings, niches, partitions, and arches.

For ceilings, stretch ceilings are often used, which fascinate with their beauty. All stretch ceilings can be glossy, matte or satin. Glossy and satin are considered the most beautiful and stylish, but matte ones are budget options. These types of ceilings are made from PVC and fabric.

The finishing of a house with a frame structure must be carried out strictly according to plan. It is important to first carefully prepare for this process and plan the design of your living space. After this, you can begin selecting materials for finishing. Wood panels are considered to be the highest quality and most durable, especially since they will harmonize most closely with the wood structure.

Interior decoration of a frame house

After the construction of the building, they begin to restore order inside. Interior work can be divided into the following finishing stages:

  • rough;
  • finishing

Rough finishing is necessary only if the building has just been built and repairs have not yet been carried out. This category of work includes:

  • pouring out floor screed;
  • wall insulation;
  • installation of windows and doors.

Finishing or fine finishing is the application of decorative materials to walls, floors and ceilings.

Rough work begins with wall cladding. Popular materials for performing this work are drywall and OSB.

Drywall

By installing this finishing material on a metal profile or wooden sheathing, you can achieve high productivity and a good final result.

Thanks to the sufficient gap between the wall of the house and the sheet of drywall, it is possible to completely hide the electrical wiring in this cavity, as well as lay a layer of insulation if necessary.

Watch an interesting video about installing drywall in a frame house:

Drywall has a small mass, so the material can be successfully used for finishing the ceiling. Multi-level ceilings made from gypsum plasterboard sheets look especially impressive.

OSB

Compared to drywall, it weighs more, so special screws are used for reliable fastening. OSB boards are not installed on the ceiling, but can be successfully used for the floor.

OSB is laid on the floor in such a way that the logs are located perpendicular to the length of the slab.

Cladding

This option for interior finishing can be considered final, because after covering with clapboard it will be enough to cover the material with transparent varnish so that the surface takes on a completely finished look.

The lining is installed on a metal or wooden frame, which is securely fixed to the main surface of the house. Then the material is attached to the sheathing using self-tapping screws.

In addition to natural lumber, artificial products can be used that imitate natural timber in their appearance. Installation is simplified due to a special latch installed at the edges.

Tile

In rare cases, the interior decoration of a frame house can be done using tiles.

Unlike installing sheet products, installing tiles requires the use of an adhesive composition. Installation work should be carried out using a level to ensure level masonry.

Which design project to choose?

When developing design options for frame houses, the customer, at his discretion, can opt for a budget (simplified) version of the structure or the layout of a house with a garage and basement.

The designer-project developer will provide the client with several (usually three) graphic options for interior planning, made using modern computer technology in excellent 3D quality, for consideration.

And finally, we should not forget that wicker chairs, wooden furniture, wild animal skins, as well as classic decorative elements look very harmonious in the interior of a frame house. They create a particularly warm atmosphere of comfort and coziness. Suspended ceilings and fashionable lamps will give the premises a modern ambiance.

Get 3 interior layout options for free

Leave a request right now and receive a free 3D interior sketch before concluding a contract

Get a 3D sketch

Wood siding

Perhaps no material can boast of such popular love as wood. This is a natural material that allows the house to breathe. You can develop a unique frame house design by choosing the siding colors to suit your taste. Wood has a unique natural pattern, which is why your home will look beautiful and fresh.

Its advantages:

  • wood has excellent thermal insulation, in our country this is especially beneficial, since heating costs are reduced, and therefore your budget is saved;
  • it is able to let in fresh air, which means your home will always have a favorable climate;
  • long service life, your home will not require significant investments for a long time.

Disadvantages include the ability to absorb moisture, so wooden siding requires additional processing and maintenance.

Block house

In appearance, a block house is practically indistinguishable from natural wood, however, it is significantly cheaper in price and is more resistant to external influences. The block house serves as a decoration for the design of a frame house: it is used for both exterior and interior decoration. If you use it for interior work, then the walls will not need subsequent wallpapering. It has all the advantages of wood, however, it is more durable and is already treated with the necessary antiseptic compounds at the production stage. Buildings built using a block house will look bright and fresh a few years after they are put into operation, since this building material is highly resistant to ultraviolet radiation.

Facade tiles

With the help of facade tiles you can implement the most daring design solution. It is widely used in the design of frame houses .

Facade tiles are a facing material that imitates brick finishing, but unlike bricks, tiles are distinguished by their variety of colors and textures.

Advantages of facade tiles:

  • ease of installation and transportation. Even not very experienced builders will be able to install it themselves;
  • with the same positive properties compared to brick, it has a lower cost;
  • with the help of this material you can implement any design solutions, both classic and original;
  • facade tiles are an environmentally friendly building material;
  • it is suitable for harsh winters, as it is characterized by significant frost resistance.

Buy a house frame without finishing in the Moscow region

1. First of all, we do not have any advance payment.
Payment only upon completion and acceptance of work at your site. 2. Payment for each individual service. We have assembled the frame, you like everything - pay for the frame, and move on. No “all inclusive”, “turnkey for 2 million” and other deceptions, there is an area and there is a cost factor and nothing more.

3. Low prices. No extra people, no “margin”, payment only for work. No hidden fees or bad news in the middle of installation. All prices are already indicated in each project and no changes can be made.

4. High quality frames. Reliable roof frames using Canadian or Finnish technology. Frame posts 150x50, floor joists and trusses 200x50. A rigid frame, regular 150×50 jibs attached to the corners of the frame, you will walk on the floor as if on a concrete floor.

5. Don’t overpay anyone. Give the complex areas (frame, roof, cladding) to us, and do the rest yourself - insulation, interior finishing.

Construction without finishing and insulation is a vital necessity. You cannot immediately insulate the frame, even if it is assembled from a dry planed board, since during assembly, even without the absence of rain, the dry board will pick up moisture like salt. If you insulate it in this form and tighten it with vapor-proof membranes, the board will begin to turn blue and rot simply because the moisture has nowhere to go.

Natural and artificial finishing stone

Natural stone is practically not used in cladding, since it is characterized by a very high cost and is difficult to finish, as it has arbitrary thickness and dimensions, as well as heavy weight.

Artificial stone is much more common, since it has a lower price, weighs significantly less and is widely available in a varied color palette.

Decorative artificial stone is widely used for both interior and exterior decoration of the house.

Artificial stone is perfect for the design of a frame house: the slabs are made in a modern or aged form.

This is an environmentally friendly material, it does not emit air pollutants, and is easy to clean. It has high thermal conductivity, so the house will not be cold.

Rating
( 2 ratings, average 4 out of 5 )
Did you like the article? Share with friends:
Для любых предложений по сайту: [email protected]